Hi,
I have a brand new board which came out of the package in loader mode when powered up. I can load firmware and make it go but each time it gets power reset it goes back into loader mode. Any reason for this?
Just curious, does the unit not work upon power up and the only way you can get it to work is to load firmware?
That is correct. Came out of the box like that. Runs fine once firmware is loaded but reverts on next power cycle.
Solving problems, one building at a time.
Haven’t seen anything close to this before. We’ll have to get the unit back for a check over. Send me an email and I’ll send you details.
Maurice Duteau