CO2-W-TH Sensors - Mass Configuration

Hello,

I have a large number of CO2_W_TH sensors I need to configure, and I was wondering if there were any “tips or tricks” with the T3000 software to make this happen en masse? I will be able to connect up to 14 of them at a time and need to change things like °C to °F, disable Auto-Calibration, change IP, disable status line, update firmware, etc…

Any way to make this process quicker? Ideally I would not have to perform these tasks manually at each sensor via the arrows.

fandu: maybe he can do a program and set the registers with that. reply to him on the forum.