In my setup i send Analog signal (1-10V) and should receive back signal of same value (1-10v).
After update to new firmware ver. (52.9) back signal is lost:
After downgrade to firmware ver. (47.5) all ok:
I would suspect that it is something wrong with OUTPUT. In T3000 output table i see output value, but i think it is not actually sending signal, can’t check it right now on site, but other data shows, that there are something wrong with two last AO :
PS. ver 51.9 same issues
Ver 51.0 works . After downgrade i see input value going up slowly, this is opening valve, so this is output issue.
07.25
53.1 have same issues
51.6 have same issues
51.5 Works